Maintenance / Cleaning - GE Evolve E2SA Guia De Instalacion

Luminaria de seguridad evolve led
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5

MAINTENANCE / CLEANING

WARNING
Risk of electric shock. Make certain power is off before
attempting any maintenance.
• To maintain high efficiency of the glass cover and
refractor, occasional cleaning of the outer surfaces
may be needed, with frequency dependent on
local conditions.
• Use a mild soap or detergent, which is essentially
neutral pH (pH approximately 6 to 8), nonabrasive,
and which contains no chlorinated or aromatic
hydrocarbons.
• Wash thoroughly, using a soft cloth.
• Rinse with clean, cold water and wipe dry.
These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in
connection with installation, operation or maintenance. Should further information be desired or should particular problems arise which are not
covered sufficiently for the purchaser's purposes, the matter should be referred to GE Lighting.
GE Lighting • 1-888-MY-GE-LED
GE Lighting Solutions, LLC is a subsidiary of the General Electric Company. Evolve and the GE brand and logo are trademarks of the General Electric Company.
© 2014 GE Lighting Solutions, LLC. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.
6
STORAGE
• Prior to installation, units should NOT be stored
outside in corrugated boxes (cardboard boxes) alone.
• Until installation, all units should be placed in a
covered dry storage area. The storage area should
not exceed -40°C (-40°F) to 50°C (122°F).
— This can be preferably in a roofed area or with a
tarp that is secured in such a way to keep water
off of the corrugated boxes (cardboard boxes).
• www.gelighting.com
(1 - 888 - 69 - 43 - 533)
35-201578-220 (Rev 08/18/14)

Publicidad

Tabla de contenido
loading

Tabla de contenido