Prepare The Collar Receiver - SportDOG SportTrainer 500 Manual De Funcionamiento

Step

Prepare the Collar Receiver

2
Charge the Collar Receiver
1. Lift the rubber cover protecting
the Collar Receiver Charging Jack.
2. Connect one of the charger
connectors to the Collar Receiver
Charging Jack.
3. Plug the charger into a standard
wall outlet.
4. Charge the Collar Receiver for
24 hours for the fi rst charge.
Recharges take only 12 hours.
Note: The Receiver Indicator Light
will fl ash after 12 hours of charging.
For the fi rst charge, continue to charge
the Collar Receiver for an additional
12 hours.
5. When charging is completed,
replace the rubber cover.
To Turn the Collar Receiver On:
1. Press and hold the On/Off Button until
the Receiver Indicator Light comes on
and the Collar Receiver beeps 5 times.
2. Release the On/Off Button.
The Receiver Indicator Light will fl ash
until the Collar Receiver is turned off. The
fl ashing light indicates the Collar Receiver
is ready to receive a radio signal from the
Remote Transmitter.
To Turn the Collar Receiver Off:
1. Press and hold the On/Off Button until the Receiver Indicator Light comes on and
the Collar Receiver beeps 2 times.
2. Release the On/Off Button.
To extend the life between charging cycles, turn the Collar Receiver off when it is not in
use. Approximate battery life between charges is 20 hours, depending on frequency of use.
6 www.sportdog.com
Charger connector
placed in Collar Receiver
Charging Jack
On/Off Button