Prepare The Collar Receiver - SportDOG SPORTTRAINER SD-800E Manual De Funcionamiento

PREPARE THE COLLAR RECEIVER

CHARGE THE COLLAR RECEIVER
1. Lift the rubber cover protecting the
Collar Receiver Charging Jack.
2. Connect one of the charger
connectors to the Collar Receiver
Charging Jack.
3. Plug the charger into a standard wall
outlet.
4. Charge the Collar Receiver for 24
hours for the fi rst charge. Recharges
take only 12 hours.
Note: The Receiver Indicator Light will
fl ash after 12 hours of charging. For
the fi rst charge, continue to charge
the Collar Receiver for an additional
12 hours.
5. When charging is completed, replace
the rubber cover.
TO TURN THE COLLAR RECEIVER ON:
1. Press and hold the On/Off Button until the
Receiver Indicator Light comes on
and the Collar Receiver beeps 5 times.
2. Release the On/Off Button.
The Receiver Indicator Light will fl ash until the
Collar Receiver is turned off. The fl ashing light
indicates the Collar Receiver is ready to receive
a radio signal from the Remote Transmitter.
TO TURN THE COLLAR RECEIVER OFF:
1. Press and hold the On/Off Button until the Receiver Indicator Light comes on and the Collar
Receiver beeps 2 times.
2. Release the On/Off Button.
To extend the life between charging cycles, turn the Collar Receiver off when it is not in use.
Note: Approximate battery life between charges is 40 hours, depending on frequency of use.
6 WWW.SPORTDOG.COM
CHARGER CONNECTOR
PLACED IN COLLAR
RECEIVER CHARGING JACK
ON/OFF BUTTON