Brilix JET SWIM ELEGANCE 70 Guía De Instalación Y Usuario página 11

9. Electric installation - WARNING
According to public order no. 50/1978 sb. only authorized person with an appropriate qualifi cation can
execute mounting and mending.
The engine has to be protected against the overloading . The whole device can be pluged in only to the power
supply protected by current protektor with residual current 0,03 A.
The tension of the electric supply must correspond to the data on the tag installed on every device. All metal
parts of the device must be connected (earthed). Electric characteristic of circuit breakers and their rules
must be in accordance with those, valid with the engine that should be protected with supposed operating
conditions. All instructions implemented by the producer must be respected (see indication on the tag).
In case of the installation with a three-phase engine, connecting parts in the terminal board must be installed
correctly (i.e. Y connection) while switching off the engine. Input and output conductors from the distribution
box must be led through bushings preventing humidity and dirt intrusion into the distribution box. Conductors
will have appropriate terminals for connection.
Electro-pneumatic switch must be installed on the dry place, above the water level in the distance not
exceeding further than 7m from the pneumatic switch installed on the 'jet swim' front. The pneumatic hose
(no. 2 in the picture 3) is designated for connecting to the electro-pneumatic switch (switchgear). It is very
important to check if the hose is not bended anywhere.
Electro-pneumatic panel is composed of:
- 1 motor protection
- 1 electro-pneumatic switch
- 1 operating fuse
All these components should be installed in the waterproof plastic box with the rate of protection of IP55.
11
EN