Installation - Brilix JET SWIM ELEGANCE 70 Guía De Instalación Y Usuario

EN
1. Installation mounting
By purchaising the ELEGANCE device, you obtained a high-quality product that will help you to enjoy
the time spent in your pool.
The 'jet swim' device, ELEGANCE is delivere, with and engine with inputs of 2,2kW. The electric pump
should be installed as close as possible to the pool in order to reach the maximum input and to reduce loss
caused by the friction. The original diameters of the accessories from the PVC materials delivered with
the installation should always be respected.
Pumps being the part of this device don't have a self-suction function. It is necessary to install them under
the water level. The technology device area must be aired sufficiently, use a fan if needed, to prevent water
condensation. You can ensure the correct functioning of the device by respecting these rules.
2. Mounting the 'jet swim' device
During the installation of the' jet swim' body, please bear in mind that it must be placed in the position
indicated in the picture 1. Displacement of a 75mm diameter and a suction of a 90mm diameter must be
installed in the vertical position that the side of the displacement is higher than the side of the suction
(90 mm diameter) see picture 1. The 'jet swim' device must be placed in a way that the centre of the jet will
be approximately 30cm under the water level. (see picture 1). You must follow and keep these instructions
and mount correctly the device to ensure the right operating of the 'jet swim'.
WATER LEVEL
30 cm
DISPLACEMENT
INTAKE
OK NO NO
Picture 1
3