Brilix JET SWIM ELEGANCE 70 Guía De Instalación Y Usuario página 8

EN
6. Minimum requirements for space and device
installation
Before the initiation of the installation, it is necessary to consider the technological housing (basin) proportions
where you want to place the 'jet swim'. Make sure in advance that you won't have any problems due to
the lack of space while mounting the pump.
Minimum recommended proportions needed for the device installation of the technological housing, see
picture 5 plus table.
width (mm)
750
WATER LEVEL
30 cm
Picture 5
length A (mm)
1420
AIR
SUCTION
INTO EL. SWITCHING
8
high B (mm)
900
VENTILATION