Brilix JET SWIM ELEGANCE 70 Guía De Instalación Y Usuario página 6

EN
4. Air and pneumatic lead installation
Air lead installation:
Stick the reducer (no. 22 picture 3) on the hose serving as an air lead and install the back-pressure valve
(no. 23 picture 3). I tis important to place a pressure-valve on the wall of the technologic housing in order
to prevent the dirt suction (see picture no. 6) Finally, fix the elastic tube (no. 13, picture no. 3) by pressing
it into a jet placed inside of the 'jet swim' body (see picture no. 4).
Pneumatic lead installation:
This lead is containing the hose (no. 21 picture 3) serving as a protective lead for the pneumatic switch hose.
Place the pneumatic switch hose into the pneumatic lead (hose no. 21 picture 2) and put its end through the
opening place in the 'jet swim' body (no. 20 picture 3) and tightened it through the brushing (no. 14). The end
of the hose (no. 2 in 13, picture no. 3) will be connected to the pneumatic switch (no. 1 in the picture 3) placed
in the front of the 'jet swim' device.
Picture 3
Picture 4
6