Technical Data; Before Starting The Equipment; General Information - Parkside ZKGS 2100 Instrucciones De Utilización Y De Seguridad

Anleitung_4300689:_ 24.11.2009

6. Technical data

AC motor:
Power:
Operating mode:
Idle speed n :
0
Carbide saw blade: ø 210 x ø 30 x 2.8 mm
Number of teeth:
Swiveling range:
Miter cut:
Saw width at 90°:
Saw width at 45°:
Saw width at 2 x 45°
(double miter cut):
Weight:
Laser class:
Wavelength of laser:
Laser output:
Laser module power supply:
Noise emission values
The saw's noise is measured in accordance
with EN 61029.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Vibration emission value a
Reduce noise generation and vibration to a
minimum!
Use only equipment that is in perfect
condition.
Maintain and clean the equipment regularly.
Adopt your way of working to the
equipment.
Do not overload the equipment.
Have the equipment checked if necessary.
Switch off the equipment when not in use.
16:21 Uhr Seite 45
230V ~ 50Hz

7. Before starting the equipment

1700 W
S1

7.1 General information

4,800 min -1
24
-45° / 0°/ +45°
0° to 45° to the left
205 x 65 mm
140 x 65 mm
140 x 40 mm
approx. 15 kg
2
650 nm
≤ 1mW
2 x 1.5 V Micro (AAA)
7.2 Assembling the saw (Fig. 1-2, 4-6)
Idle speed
86 dB
3 dB
99 dB
3 dB
< 2,5 m/s 2
h
Wear gloves.
The equipment must be set up where it can
stand securely, i.e. it should be bolted to a
workbench, a universal base frame or
similar.
All covers and safety devices have to be
properly fitted before the equipment is
switched on.
It must be possible for the blade to run
freely.
When working with wood that has been
processed before, watch out for foreign
bodies such as nails or screws, etc.
Before you press the ON/OFF switch check
that the saw blade is fitted correctly. Moving
parts must run smoothly.
Before you connect the equipment to the
power supply make sure the data on the
rating plate are identical to the mains data.
To adjust the turntable (16), loosen the
locking grip (13) by approx. 2 turns, which
frees the turntable (16) (Fig. 4).
To release the saw from its bottom position,
apply light downward pressure to the
machine head (5). At the same time pull the
safety pin (25) out of the motor mount. Turn
the safety pin (25) through 90° so that the
saw remains unlocked (Fig. 1-2).
Swing the machine head (5) up until the
release lever (3) latches into place (Fig. 1).
Fit the clamping devices (8) on the left
and/or right side of the fixed saw table (17)
(Fig. 1).
Undo the locking screws for the workpiece
support (10) (Fig. 5).
Mount the workpiece support (9) on the
fixed saw table (17) and tighten the
appropriate locking screw (10) (Fig. 5).
Mount the second workpiece support (9) on
the opposite side of the saw and secure
with the appropriate locking screw (10).
When the locking screw (23) is loosened,
GB/
MT
45