Visual Inspection - 3M ReLoad SRL Instrucciones De Usuario

Mode d'emploi • Instrucciones de usuario •
2.2.2 Webbing SRL:
Webbing SRLs incorporate an energy absorbing component within the webbing lanyard. Inspect the energy
absorber to determine if it has been deployed. Deployment is clearly indicated by a red warning symbol
displayed on the lanyard (See Figure 10). Ensure the clear plastic energy absorber cover is secure and not
damaged or torn. If inspection reveals the SRL has received an impact load it should be removed from
service immediately and recertified by an authorized person.
NOTE: Authorized person means a person who is trained and approved by 3M to identify hazards or dangerous
conditions of the self retracting lanyard.
Figure 10—Deployment of tear webbing absorber

2.3 Visual inspection:

Perform the following checks in sequence. If you have any doubts about any of the inspection checks to
be performed below, consult 3M Technical Service or an authorized person who is qualified to perform
inspections.
It is the responsibility of the site safety officer or the user to maintain a record of each periodic inspection
in the inspection log, which can be found at the back of this manual. See Section 6.
A. BEFORE USE/AS SUPPLIED
B. DEPLOYED VISUAL LOAD INDICATOR
C. Red warning symbol visible, indicates deployment/fall
arrest
55
User instructions