3M ReLoad SRL Instrucciones De Usuario página 57

Mode d'emploi • Instrucciones de usuario •
Check 1. Inspect the SRL to see if the visual load indicator has deployed. This indicates if a fall has
occurred and if the SRL has been subjected to fall arrest loads. See Section 2.2 for load indicator
inspection.
Check 2. Inspect to ensure all labels are present and fully legible. See Section 4.0.
Check 3. Inspect connecting hooks or carabiners for signs of damage, corrosion, and working condition.
Check 4. Inspect the casing for signs of damage or distortion.
Check 5. Inspect the eyelet on all cable models for signs of damage or distortion. The swivel eye on
webbing models must turn freely, the spiral pin must be present and securely fixed, and the fastening
bolt must be flush with eyelet surface. If fastening bolt is sub-flush, please contact an authorized person.
Check 6. Ensure all fastenings are present and secure.
Check 7. Ensure that it is possible to completely extract the lanyard. As the lanyard retracts it must do
so without hesitation (no slack line should occur). During extraction and retraction ensure that a clicking
sound can be heard which indicates that the locking mechanism is functioning correctly.
Check 8. Pull the lanyard sharply making sure that this causes the device to lock up.
Check 9. Visually inspect the entire unit for signs of corrosion.
NOTE: Authorized person means a person who is trained and approved by 3M to identify hazards or dangerous
conditions of the self retracting lanyard.
User instructions
57