Shark S3901 Serie Guia Del Usuario página 16

NOTE: Additional mop pads and accessories
are available to further improve your cleaning
performance. See page 28 for more details.
IMPORTANT: When you are using the mop for
the first time, it might take longer than the normal
30 seconds to start steaming.
Floor Cleaning
6 Sweep or Vacuum your floors prior to mopping.
7 Plug the power cord into an outlet. The STEAM
CONTROL button will flash blue.
IMPORTANT: Make sure you do not use the mop
without attaching a cleaning pad and adding water to
the tank first.
8 Press the STEAM CONTROL button to select your
steam setting:
Once for (DUST) , twice for
times for (SCRUB). Pressing a fourth time will
place the unit on standby. (fig. 6)
9 Use the shaggy side of the cleaning pads to lift up and
lock away all the dirt and debris and the scrubbing
side to break up tough stains.
16 1.800.798.7398
fig. 6
10
11
(MOP), and three
When the water tank is empty, the steam mop will
stop producing steam. You can refill the water tank
at any time as long as the mop is unplugged from
the outlet. Follow the instructions from page 14. This
applies to switching the mop heads or cleaning pads
as well.
When you are done, press the STEAM CONTROL
button until the light blinks blue as in standby mode.
(fig. 7)
NOTE: When using your Shark
Steam Pocket Mop in MOP mode be careful not
®
to press the steam trigger on the Handheld Steamer, as
it will activate STEAM SETTING mode. If this happens,
press the STEAM CONTROL button one time to
reactivate your steam selection.
fig. 7
Lift-Away Pro
® ™