Scott Procap Instrucciones De Uso página 38

38
! Fix eventually removed face seal.
! Place the wiper in its groove.
! Place the face shield in the carriages and secure with screws.
Wheel carriage
! Remove the face shield from the helmet's wheel carriages.
! Remove the carriages from the slide bars, sliding them from front to back.
! Slide in new carriages and push them against the brow seal.
! Prior to mounting the face shield, check that the wiper is in its groove. Place
the face shield in the carriages and secure with screws.
Welding shield
Removal and mounting of the welding shield is done in the same manner as the main visor.
o
Welding Þ lters are Þ tted from the back of the ß ip-up frame (fenestra) and retained by a spring
o
clip. The spring clip can be detached and hinged outwards by pressing upwards and outwards
from the bottom
•
Fit always an anti-spatter lens (064497) in front of the welding Þ lter
to protect it from sparks.
•
Fit the welding Þ lter. Then, if desired, Þ t a further anti-spatter lens behind
the welding Þ lter (compulsory if the welding Þ lter is made of glass).
•
Put the retaining clip back into its recess at the bottom.
•
A further anti-spatter lens can be Þ xed in the frame of the welding shield, to protect the main
visor (e.g. grinding)
Helmet
Brow seal
! Loosen the screws of the brow seal (4 pcs) and remove it.
! Set a new seal into place. When the edge groove of the seal grips the teeth in the shell, the
screw holes will come aligned.
! First screw in the two outermost screws, then the ones in the middle.
Headband
! Remove the brow seal.
! Lift the headband fasteners (anchors) (4 pcs) from the notches inside the shell.
! Slot a new headband into place. Check that the anchors are pressed down to the bottom of the
notches.
! Fix the brow seal.
Airduct
! If needed, remove the headband.
! Remove the airduct.
! Place the splitted end of a new airduct into place by stufÞ ng the two outermost ß aps in the
hose socket and letting the broad ß ap stay out.
! Insert the other end right under the brow seal.
! Press the edges of the airduct carefully in the shell groove to eliminate any leaks.
! Slot eventually removed headband back into place. Check that the anchors are pressed down
to the bottom of the notches.
* * * * * * *