Preselecting The Speed; Maintenance And Care - Flex PE 14-2 150 Instrucciones De Funcionamiento

Preselecting the speed

 To set the operating speed, move the dial
to the required value.
 Gently press the switch to accelerate the
power tool up to the preselected speed.
CAUTION!
Risk of injury due to destruction of the tool.
Use the appropriate tool for the job.
NOTE
If an overload or overheating occurs during
continues operation, the power tool auto-
matically reduces the speed until the power
tool has cooled down adequately.
Attaching the tool holder
 Pull out the mains plug.
 Press and hold down the spindle lock (1.).
 Screw the tool holder (Velcro pad, fleece
pad) clockwise onto the spindle and
tighten hand-tight (2.).
 Attach the tool to the tool holder.
 Insert the mains plug into the socket.
 Switch on the polisher (without engaging
it) and run the polisher for approx.
10
30 seconds. Check for imbalances and
vibrations.
 Switch off the polisher.
Changing the tool holder
 Pull out the mains plug.
 Press and hold down the spindle lock.
 Unscrew tool holder anti-clockwise and
screw it off the spindle.
 Attach new tool holder (see above).
Attaching the tools
CAUTION!
Attach the tools in the centre of the tool
holder. Imbalances may damage the power
tool. The work result may be impaired.
Operating instructions
NOTE
When the power tool is switched off, the tool
continues running briefly.
If using a polishing paste, use the respective
tool for each paste.
On sensitive surfaces (e.g. car paintwork)
do not work aggressively but work at slow
speeds applying low contact pressure.
Sponges can be washed in the washing
machine.
For further information on the manufacturer's
products go to www.flex-tools.com.

Maintenance and care

WARNING!
Before carrying out any work on the polisher,
always pull out the mains plug.
Cleaning
WARNING!
If metals are work over a prolonged period,
conductive dust may become deposited
inside the housing. Impairment of the protec-
tive insulation! Operate the power tool via
a residual-current-operated circuit-breaker
(tripping current 30 mA).
Regularly clean the power tool and
ventilation slots. Frequency of cleaning is
PE 14-2 150