Flex FX3181 Manual Del Operador página 13

FILTER COVER (FIG. 7)
Using the filter cover will improve the
performance and extend the life of the tool.
a. Remove the battery pack.
b. To attach the filter cover, snap the filter cover
onto the tool foot.
c. To remove the filter cover, insert a flathead
screwdriver (not supplied) into the notch at
the top of the filter cover and pry the filter
cover away from the tool.
Clean the Filter cover
To clean the filter cover, tap it against a hard
surface or blow it clean with compressed air.
WARNING
or glasses with side shields.
INSTALLING THE AUXILIARY HANDLE
The auxiliary handle, used to guide and balance
the tool, can be threaded into the front housing
on either side of the tool, depending on personal
preference and comfort.
Thread the auxiliary handle into the desired
position and securely tighten it in place.
To reduce the risk of
injury, wear safety goggles
(FIG. 8)
Fig. 7
Fig. 8
-13-
Filter Cover
Auxiliary Handle