Welding Preparation - Leister WELDPLAST S4 Instrucciones De Funcionamiento

Welding preparation

• The temperature control prevents the hand extruder from being started while it is cold.
Drive status
Heating
display (30)
Heating until ideal
values are reached
• The device heats up to the last ideal temperature set directly after switching on the main switch (1). When the
ideal temperature is reached, a counter on the status display counts back from 30 seconds to zero. After this
start-up process is complete, the device is ready to weld (status Ready*). The hand extruder takes around
5 minutes to reach its temperature range.
Software and menu guide
• The hand extruder Weldplast S4 is provided with a convenient user software, making work easier for the user.
Tap lightly on the keys to operate them.
Workspace functions
Menu selection
Set contrast
Heating on/off
Change cursor position
Selected value [+]
Selected value [–]
Start window
• After turning on the hand extruder
with the main switch (1), the device
name and current software version
will be displayed for 3 seconds.
Setting the parameters in the workspace
• The cursor (31) shows which parameters
can be set. After the device is switched on,
the cursor is situated on «SPEED». «AIR» or
«PLAST» can be selected with the Select
key (28) and their values can be changed
using the Up key (29) or Down key (27).
Start-up waiting period:30 seconds
Motor disabled
Menu selection functions
Menu selection / Back to workspace
Back to workspace (changes not saved!)
Select and back to workspace
Select
Cursor up / Selected value [+]
Cursor down / Selected value [–]
SPEED
Set value
M free
Motor release
Workspace
• The workspace shows
the parameters which
are currently set.
AIR
Set value
Ready*
Ready to weld
PLAST
Set value
21