Operating Instructions For Welding Data Recording; Operating Unit; Display Description - Leister GEOSTAR G5 Instrucciones De Servicio

Operating Instructions for Welding Data Recording

(Translation of original operating instructions)
Read the operating instructions for the respective device carefully before use.
This document is the operating instructions for the additional welding data recor-
ding function and is intended to supplement the device operating instructions.

Operating Unit

27
28
29
30

Display Description

Status display "Section 1" (35)
Name of the saved
value
230 V
001
Status display "Section 2" (36)
Warning present
(see Chap. Warning & Error Messages)
Key lock
(only with active key lock)
Data recording
(see Chap. Running Welding Data
Recording)
31 32 33
Profile currently selected. If names consist of more than 6 characters, the first 6
characters are shown first, followed by the remaining characters.
Network voltage currently present on the mains plug
Current file number of the welding data record
35
36
34
27. "Up" key
28. "Down" key
29. Key for heating "On/Off"
30. Key for drive "On/Off"
31. Status LED
32. "e-Drive"
33. Function display
34. Working display
35. Status display "Section 1"
36. Status display "Section 2"
Undervoltage
Heating
(only with activated heating)
WLAN
(see Chap. Data
Synchronization)
EN
1.
Overvoltage
GPS
27