Setting The Drive Speed; Setting The Welding Temperature - Leister VARIANT T1 Instrucciones De Funcionamiento

1. Work Mode

1.3 Setting the drive speed

• The drive speed can be adapted with the Drive
the e-Drive
ting can be carried out with the drive switched on or switched off. If no entry is made
by the controls (4) within 3 seconds, the new drive speed will be accepted.
The Setpoint Value display or Cool Down menu appears on the display (5) (Fig. 9).
• If the welding nozzle (9) is not in the welding position, the (Start)
will appear at the bottom left of the display (5).
• The drive can be switched on by pressing the e-Drive , after which the
(Stop)
e-Drive .
• Pressing the e-Drive
display or Cool Down menu appears on the display.
• If the Drive
Length Measurement, Blower and Drive Counter).
• You can change to the relevant menu by pressing the Heating
Profile

1.4 Setting the welding temperature

• The welding temperature can be changed with the Heating Save
temperature can be set in 10°C increments from 100°C to 620°C by turning the
e-Drive . The setting is accepted after 3 seconds, as long as no button is pressed
within these 3 seconds (Fig. 10).
• If this menu is called up from the Setpoint Value display, the heating and blower
can be started by pressing the e-Drive
Reset
the Cool Down menu can be selected (Section 1.8 Cooling) (Fig. 11).
• If the Heating
the drive speed. This call-up is only possible from the Work display (Section 1.2).
(Only possible with VARIANT T1 230 V~).
• You can change to the relevant menu by pressing the Drive
in 0.1 m/min. increments from 1.5 m/min. to 18.0 m/min. This set-
symbol will appear. The drive speed can be adjusted directly by turning the
again executes the Stop command, which switches off the drive. The Setpoint Value
button is pressed for 3 seconds, the display will change to another menu (see Section 1.6
button is pressed for 3 seconds, the mains voltage will appear below
button. This can be set by turning
Profile
Save
or Blower
button. The welding
Reset
. Once the heating is switched on,
or Blower
6.0
620
symbol
(Fig. 9)
button.
6.0
620
100
(Fig. 10)
6.0
button.
520
80
Profile
(Fig. 11)
%
%
29