Welding Preparation - Leister WELDPLAST S2 Manual Del Usaurio

Welding preparation

The temperature control prevents the hand extruder from being started while it is cold.
Drive status
display (30)
Heating until ideal
values are reached
The device heats up to the last ideal temperature set directly after switching on the main switch (1). When
the ideal temperature is reached, a counter on the status display counts back from 30 seconds to zero. After
this start-up process is complete, the device is ready to weld (status Ready*). The hand extruder takes around 4
minutes to reach its temperature range.
If the power is only turned off for a short time, the start-up process does not need to be repeated.
Software and menu guide
The hand extruder Weldplast S2 is provided with a convenient user software, making work easier for the user. Tap
lightly on the keys to operate them.
Workspace functions
Menu selection
Set contrast
Heating on/off
Change cursor position
Selected value [+]
Selected value [–]
Start window
After turning on the hand extruder
with the main switch (1), the device
name and current software version
will be displayed for 3 seconds.
Setting the parameters in the workspace
The cursor (31) shows which parameters can be
set. After the device is switched on, the cursor
is situated on «SPEED». «AIR» or «PLAST» can
be selected with the Select key (28) and their
values can be changed using the Up key (29) or
Down key (27).
20
Start-up waiting period: 30 seconds
Motor disabled
Heating
Motor release
Menu selection functions
Menu selection / Back to workspace
Back to workspace (changes not saved!)
Select and back to workspace
Select
Cursor up / Selected value [+]
Cursor down / Selected value [–]
Workspace
The workspace shows the
parameters which are
currently set.
Set value
M free
Ready to weld
Set value
Ready*
Set value