TECHNICAL DATA
TYPE
WORKING PRESSURE Bar
AIR CONSUMPTION l/min
SPEED CONTROL
RPM
ORBITAL DIAMETER mm
DISC PAD DIAMETER mm
EXTRACTION SYSTEM
WEIGHT Kg
GENERAL WARNINGS
The tool must be connected to a suitable dust extraction system (not supplied).
SAFETY AND ACCIDENT PREVENTION INSTRUCTIONS
The safety and accident prevention instructions are reported in
the "SAFETY INSTRUCTION" booklet which forms an integral part
of these documents; the operating instructions indicate the
additional information required specifically for use of the tool.
Never use the tools without the safety guards.
Any operations carried out on the tool must be effected with the
tool disconnected.
Before starting the tool, ensure that it is held tightly and not in
contact with the work surface.
The electric tool must be connect to a suitable dust extraction unit
and applicable safety regulations must be observed if dusts
dangerous to health are likely to occur during sanding.
Due to risks that may arise during sanding, we recommend the
constant use of P .S.D. (personal safety devices such as gloves,
headphones, goggles, face masks, etc.) according to laws in for-
ce to prevent or reduce accident probability.
8
TA531A
6
400
YES
10.000
3
150
YES
1,5
Warning! Carry out the lubrication process outlined on page 10,
in the maintenance paragraph. The appliance continues to work
for a few seconds after it has been switched off.
CORRECT USAGE
The sanders are designed for sanding wood, plastic, composite
materials, paint/varnish, filling material and similar materials.
Metal and materials with an asbestos content must not be
processed with these tools.
The tools must not be damp nor operated in a damp environment
for electrical safety reasons.
The tools may only be used for dry sanding.
Make sure the work piece is sufficiently fastened.
In the event of improper use, the user is fully liable for any
damages or accidents.
ENGLISH
TA551A
TA562AN
6
6
400
400
YES
YES
10.000
10.000
5
5,2
150
200
YES
YES
1,6
2,0
8