Murray ELT155420H Manual Del Operador página 13

How To Drive In Reverse
1. (Figure 11) Look to the rear.
2. Slowly push the speed control pedal (A) to the
REVERSE position (B).
How To Change Directions
CAUTION: To change directions, do not use the
left brake pedal. Use only the speed con trol pedal.
1. (Figure 11) Slowly remove your foot from the
control pedal (A). The speed control pedal (A)
will automatically return to the NEUTRAL position
(C).
2. When the unit stops, slowly move the
pedal (A) to the desired direction.
How To Disconnect The Transmission (Figure 10)
To push the unit, use the automatic drive dis connect
(A) to release the transmission. The engine must be off.
3. Move and latch the automatic drive dis connect
(A) in the PUSH position (C). The transmission is
now released and the unit can be pushed.
NOTE: In cold weather, the heavy viscos ity oil in the
transmission will make the unit difficult to push.
4. To engage the transmission, unlatch the
drive dis connect (A). The trans mission is now
connected and ready to operate.
How To Use The Parking Brake (Figure 8)
1. Completely push the brake pedal (B) for ward.
2. Lift the parking brake lever (F).
3. Remove your foot from the
release the parking brake lever (F). Make sure the
parking brake will hold the unit.
4. To release the parking brake lever (F), completely
push the brake pedal (B) forward. The park ing brake
will automatically release.
WARNING: Before you leave the operator's
position, set the parking brake. Move the
blade rotation con trol to the DISENGAGE
position. Stop the engine and remove the
ignition key.
speed
speed control
automatic
brake pedal (B) and then
How To Change The Cutting Height (Figure 8)
To change the cutting height, raise or lower the lift lever
(E) as follows.
1. Move the lift lever (E) forward to lower the mower
housing and back to raise the mower housing.
2. When you ride on a sidewalk or road, move the
lever (E) to the highest position and move the blade
rotation control (A) to the DIS ENGAGE position.
How To Stop The Unit (Figure 8)
1. Slowly remove your foot from the
pedal (D). The speed control pedal (D) will
automatically return to the NEUTRAL position and the
unit will stop.
2. Move the blade rotation control (A) to the
DISENGAGE position.
3. Set the parking brake (F).
WARNING: Make sure the parking brake will
hold the unit.
4. Move the throttle control (G) to the SLOW position.
5. To stop the engine, turn the
OFF position. Remove the key.
How To Transport The Unit
To transport the unit, follow the steps below.
1. Move the blade rotation control to the DIS ENGAGE
position.
2. Raise the lift lever to the highest position.
3. Move the throttle control to a position be tween SLOW
and FAST.
4. Slowly push the speed control pedal forward to the
desired speed.
lift
speed control
ignition key (C) to the
11