HP LaserJet 5100 Mantenimiento página 26

3
Hint For reassembly, insert the pin on the left side of the cover first.
4
5
Note The fuser power connection is on the left side of the assembly. To
disengage and remove the fuser from the printer, pull strongly on the
left side of the fuser.
Figure 18 Removing the fuser (rear view of the printer)
24
Installing the printer maintenance kit
Slide the door to the left, and then remove it from the printer.
Facing the back of the printer, remove the two machine screws
(Figure 18, item 3) holding the fuser (item 2) in the chassis.
Using a small, flat-blade screw driver, lift at area 4 in Figure 18 to
disengage the fuser assembly. Grasp the green handles (item 1)
and strongly pull the fuser out of the chassis.
ENWW