Explanation Of The Switches And Their Uses - SPM FROSTY DREAM 2 Manual De Instrucciones

6 - EXPLANATION OF THE SWITCHES AND THEIR USES

a) Activate the general switch (D) (see figure 7):
b) Each tank is controlled by three switches which are
activated as follows:
- to make ice slush or sorbets: first select the switch
(E) to start up the mixer components (the green
LED on the switch will light up to confirm the
selection has been made), then select the switch
(F) to activate the cooling system.
N.B. The machine is equipped with a delay system
for the activation of the compressors, so the green
LED for the switch (F) will not light up until four
minutes after it has been turned on.
- To make cold drinks: first select the switch (E) to
start up the mixer components (the green LED on
the switch will light up to confirm the selection has
been made), then select the switch (G) to activate
the cooling system at a positive temperature.
Warning: Never turn all the switchs F and G on at the
same time.
Warning !!
If the machine is turned off at night, with the bowls filled,
or just partially filled, a layer of solid ice may form on the
surface, due to the natural separation of the unmixed
product. In this case, before turning the machine back
on, remove the layer of superficial ice, so as to prevent
damage to the mixing spiral.
Fig. 7
19