SPM FROSTY DREAM 2 Manual De Instrucciones página 23

d) Cleaning the dispensing tap:
- simultaneously apply pressure to the two securing
tabs (Q), and lift the dispensing tap (I) to pull it out of
its fixed position (see figure 14).
- Remove the dispensing tap by keeping the indicated
part (R) pressed down and slipping off the
dispensing lever (L) (see figure 15).
- Thoroughly wash each single part with hot water
and dish washing detergent, rinse well, and
reassemble the parts.
e) Unscrew the securing bolt (S) in the direction of the
arrow (threading on the left), pull off of the mixing unit
(U), and remove the sealing washers (X) and (T) (see
figure 16).
f) Thoroughly wash each single part, and properly base
(Y), as well as the evaporator (Z) (see figure 17).
Fig. 14
Fig. 15
Fig. 16
Fig. 17
23