SPM FROSTY DREAM 2 Manual De Instrucciones página 25

m) Reassemble the upper mixing unit (O) so that its
toothed crown is aligned with the lower crown. This will
allow the front pin to fit perfectly into its fixed position
on the bowl (see figure 22).
n) Remove the liquid-collector tray (AA) turning it slightly
upwards and pulling it forward (see figure 23). Wash
each part thoroughly, then reassemble the parts by
inversely following the procedures described above.
Make sure that the condensation drainage tube (AB)
is reinserted into its correct fixed position.
Fig. 21
Fig. 22
Fig. 23
25