Screen Control; Sound Control - Arregui BASA 20000-S7 Manual De Instrucciones

The identification codes for the actions are:
EL: door closed with electronic code
EU: door opened with electronic code
OL: door closed with emergency key
OU: door opened with emergency key
The date and time are displayed using the YYMMDD (Year, Month, Day) and HH,mm (Hour, minute)
format.
In order to access this function:
A. Press 00 and the E button. The screen will display SELECT.
B. Press the 3 button. The screen will display PASS.
C. Enter the master code and press the E button.
The screen will display all the information for the first action (A001). Press the 4 button for the pre-
vious action and the 6 button to move to a subsequent action.
9. Other control elements
SCREEN CONTROL: To configure the screen so it does not display the digits that are entered, press
the C button and then the 3 button. If you would like the screen to display what you enter, press the
C button again.
SOUND CONTROL: To use the safe in silent mode, press the C button and then the 6 button. If you
would like the safe to emit sounds again, press the C 6 button again.
BATTERY STATUS CONTROL: If you would like to know whether the batteries are sufficiently charged,
press the E button while the safe is closed. If the batteries are fine, the screen will display HI-BAT, and
if they are not, the message will be LO-BAT. In that case, you should replace the batteries with new
ones.
In any case, if the batteries are not sufficiently charged, the system will warn you of this when the
safe is opened and closed by displaying the OPEN LO-BAT or CLOSE LO-BAT messages on the screen,
respectively.
NOTE: During the battery change process, the safe will not forget the codes that have been entered.