Iso Ddin Radio Provision; Models Without Factory Nav - Metra 99-9605B Instrucciones De Instalación

ISO DDIN radio provision

1. Slide the radio into the radio housing
and then secure it using the screws
supplied with the radio. (Figure A)
2. Slide the radio housing into the radio
frame assembly removed in dash
dissassembly. (Figure B)
3. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections
to the radio and HVAC controls. Metra
recommends using the proper mating
adapter from Metra and/or AXXESS.
Test the radio for proper operation.
4. Place the radio brackets around the
radio housing assembly and then secure
it using the (2) 8 x 3/8" Phillips screws
provided. (Figure C)
5. Reassemble the upper dash in reverse
order of disassembly.
KIT ASSEMBLY
(Figure A)
(Figure B)
(Figure C)
For models without factory navigation:
1. Secure the HVAC controls into the lower
location of the lower console using the
screws removed in dash disassembly.
(Figure A)
2. Snap the climate trim panel with pocket
into the lower console location. (Figure B)
3. Reassemble the lower dash in reverse
order of disassembly.
(Figure A)
(Figure B)
REV. 4/11/2018 INST99-9605B
7