Publicidad
7
WORK POSITIONING and RESTRAINT
EN 358: 2000 harness
for work positioning and
restraint
These attachment points
are designed to either hold
the user in position at the
work-post, or to prevent the
worker from entering a zone
where a fall is possible. These
attachment points must only
be used to attach to a restraint
or work positioning system,
maximum fall height: 0.5 m.
These attachment points are
not designed for fall arrest use
and it may be necessary to
supplement work positioning
or restraint systems with
collective fall arrest systems
(e.g. safety nets) or personal
fall arrest systems (e.g. an
EN 363 fall arrest system).
8
ROPE ACCESS
Seat harness:
EN 813: 1997
Ventral attachment point
The EN 813: 1997 standard concerns seat
harnesses that are used in work positioning,
restraint, and rope access systems when a low
attachment point is necessary.
Use this ventral ring to attach a descender,
positioning lanyards or progression lanyards.
This attachment point should not be used to
attach fall arrest systems.
5
NAVAHO BOD C71000 B / NAVAHO BOD FAST C710F0 B / NAVAHO BOD FAST NOIR C710FN B
7A. Ventral attachment point
7B. Lateral belt attachment points
Always use the two lateral attachment points together
by linking them with a positioning lanyard in order to be
comfortably supported by the waistbelt.
7A.
7B.
Examples:
GRILLON
EN 358
Maximum
height of
fall : 0,5 m
9
Equipment loops
Equipment loop maximum load
10 kg
maxi
Slot
for tool
carrier
15 kg maxi
7C. Rear restraint attachment point
This attachment point on the back
of the waistbelt is designed only for
attachment of a restraint system to
prevent the user from entering an area
where a fall is possible.
Regularly verify the length of the
restraint and/or work positioning
lanyard during use.
7C.
Examples:
The
equipment
loops must
only be used
to attach
and support
10 kg
equipment.
maxi
WARNING
DANGER,
10 kg
never use
maxi
equipment
loops for
belaying,
rappelling,
tying-in, or
anchoring a
person.
C715000C (060112)
10
Supplementary information
regarding standards (EN 365)
Rescue plan
Various
You must have a rescue plan
- Users must be medically
and the means to rapidly
fit for activities at height.
implement it in case of
WARNING, inert suspension
difficulties encountered while
in a harness can result in
using this equipment. This
serious injury or death.
implies adequate training
- You must verify the
in the necessary rescue
suitability of this equipment
techniques.
for use in your application
Anchors
with regard to applicable
The anchor point of the
governmental regulations
system should preferably
and other standards on
be located above the user's
occupational safety.
position and must conform
- The instructions for use
to the requirements of
for each item of equipment
the EN 795 standard, in
used in conjunction with this
particular the minimum
product must be respected.
strength of the anchor must
- The instructions for use
be 10 kN.
must be provided to users
Work environment:
of this equipment. If the
Be vigilant when working
equipment is re-sold outside
near sources of electricity,
the original country of
moving machinery or
destination the reseller shall
abrasive or sharp surfaces.
provide these instructions in
WARNING, chemical
the language of the country
products, heat and corrosion
in which the product is to
can damage your harness.
be used.
In these environments, you
must frequently inspect the
condition of the harness
during use.
Publicidad
