Setting Remote Control Code Type - Pioneer AVR-W6100 Manual Del Usaurio

Using the Remote Control

Setting remote control code type

When the remote control operation switch is set to DVD, changing the remote control code
type enable to operate the Pioneer DVD player by the supplied remote control. There are
three remote codes, code type A, code type B and code type DVH.
When using this unit with "XDV-P9
When using this unit with a DVD Navigation Unit, select code B.
When using this unit only, select code DVH.
When using this unit with "SDV-P9" or "AVX-P7300DVD" DVD players, select code A
or B. (Depending on reception signal setting of DVD player.)
1. Set the remote control selection switch on the left side of the remote control
to appropriate position with a pen tip or other pointed instrument .
• If you selected DVH mode, there is no need to operate the following procedure.
• If you selected A/B mode, read the following procedure and change the code type into
the appropriate one.
2. Pressing 7 and 0 on the remote control simultaneously changes the code type.
Initially, code type is set to A.
Each time you press 7 and 0 on the remote control simultaneously changes the code type
between A and B.
9
" or "XDV-P9" Multi-DVD Players, select code A.
II