Light Bulbs; Install Filters - Broan Elite RMIP33 Instrucciones De Instalación

19. LIGHT BULBS

This insert uses 50 W halogen lamps (120 V, 50 W, PAR 20) (Purchase separately).
Install the lamps by rotating them clockwise into their socket holder.

20. INSTALL FILTERS

It is recommended to install side filters first and finish with center one(s).
1.Insert upper end of filter into the insert (finger sized cup side).
2.Raise lower end of filter to position it into grease rail inside of hood and pull.
3.While pulling the filter, slide it under the inner retaining piece.
Replacement filters are available from your dealer. See inside label insert for size and part number.
1
2
3
HD0086
Baffle Filters
Baffle filters are available as an option. To order them, refer to the table below to find the
right filter kit number for your insert. To install them, refer to instruction sheet included with
baffle filter kit.
21. USE AND CARE
Grease filters and impeller(s).
The grease filters, impeller(s) and grease rail should be cleaned frequently. Use a warm detergent solution. Grease
filters and impeller(s) are dishwasher safe.
Remove greasse filters by pushing them towards the back of hood and rotating downward.
Clean all-metal filters in the dishwasher using a non-phosphate detergent. Discoloration of the filter may occur if using
phosphate detergent or as a result of local water conditions—but this will not affect filter performance. This discoloration
is not covered by the warranty.
Stainless steel cleaning: How to maintain its «BRIGHT LOOK»
Do:
• Regularly wash with clean cloth or rag soaked with
warm water and mild soap or liquid dish detergent.
• Always clean in the direction of original polish lines.
• Always rinse well with clear water (2 or 3 times) after
cleaning. Wipe dry completely.
• You may also use a specialized household stainless
steel cleaner.
HD0031
1) Finger sized cup
KIT NO. INSERT MODEL
RBFIP33 RMIP33
RBFIP45 RMIP45
Don't:
• Use any steel or stainless steel wool or any other
scrapers to remove stubborn dirt.
• Use any harsh or abrasive cleansers.
• Allow dirt to accumulate.
• Let plaster dust or any other construction residues
reach the hood. During construction/renovation, cover
the hood to make sure no dust sticks to stainless steel
surface.
- 12 -
1
HD0011
( )
BAFFLE FILTER TYPICAL