Light Bulbs - Broan best WPD28I Manual Del Usuario

10. LIGHT BULBS

This hood must use 120V, 50W max., type GU10 shielded halogen lamps (included).
In order to prevent the risk of personal injury, do not install a lamp
identified for use only in enclosed fixtures.
1. Install lamps by placing the bulb leads into their grooves in the socket and
gently push upward and turn clockwise until secured.
2. Install trim rings by gently pushing upward and turning clockwise until
secured.
11. INSTALL BAFFLE FILTERS
Remove protective plastic film covering the baffle filters before installing them.
It is recommended to install side filters first and finish with center one(s).
A vertical arrow with the word AIR can be found on the filters border. Make sure
to install the baffle filters with the arrow pointing towards the inside of the hood.
See figure beside.
1. Insert upper end of baffle filter into the hood.
2. Raise lower end of baffle filter to position inside of hood and push to insert
the rear clip inside its slot in baffle back side.
3. While pushing the baffle filter, slide it under the inner retaining piece.
Make sure the baffle filters are positioned as shown beside in order to allow the
grease to reach the grease rail easily.
! WARNING
CAUTION
- 8 -
HD0078
HO0026
1
2
3
HO0027