Fein KBM80U Manual Del Usaurio página 5

3 41 01 126 21 0.book Seite 5 Donnerstag, 21. Januar 2010 1:48 13
Special safety instructions.
Wear personal protective equipment. Depen-
ding on the application, use a face shield,
safety goggles or safety glasses. Wear ear pro-
tection. The safety glasses must be capable of
protecting against flying particles generated
by the various different operations. Prolon-
ged exposure to high intensity noise may
cause loss of hearing.
Secure the power tool with the clamping strap
supplied if there is danger of it falling, especially
for work carried out at a height, on vertical
construction elements or above the head. If there
is a power cut, or the mains plug is pulled out,
the magnetic holding power is not maintained.
When working overhead or on vertical sur-
faces, the coolant container must not be used.
Use a coolant spray instead. Liquids penetra-
ting your electric power tool may cause elec-
tric shock.
Avoid touching the drilled core that is automati-
cally ejected by the centering pin when the
working procedure is finished. Contact with
the core when it is hot, or if it falls, can cause
personal injuries.
Operate the power tool only from earthing con-
tact sockets that comply with the specificati-
ons. Do not use any connection cables that are
damaged; use extension cables with an eart-
hing contact that are checked at regular inter-
vals. A earth conductor without continuity
can cause an electric shock.
Do not machine any material containing asbes-
tos. Asbestos is cancerogenic.
Handling hazardous dusts
When working with power
WARNING
tools, such as when grinding,
sanding, polishing, sawing or for other work
procedures where material is removed, dusts
develop that are both hazardous to one's health
and can spontaneously combust or be explo-
sive.
Contact with or inhaling some dust types can
trigger allergic reactions to the operator or
bystanders and/or lead to respiratory infec-
tions, cancer, birth defects or other repro-
ductive harm.
To prevent injuries, always keep your hands,
clothing, etc. away from rotating swarf. The
swarf can cause injuries. Always use the chip-
ping protector.
Do not attempt to remove the application tool if
it does not turn. This can lead to serious inju-
ries.
Do not rivet or screw any name-plates or signs
onto the power tool. If the insulation is dama-
ged, protection against an electric shock will
be ineffective. Adhesive labels are recommen-
ded.
Do not use accessories which are not specifi-
cally designed and recommended by the power
tool manufacturer. Safe operation is not ensu-
red merely because an accessory fits your
power tool.
Clean the ventilation openings on the power
tool at regular intervals using non-metal tools.
The blower of the motor draws dust into the
housing. An excessive accumulation of metal-
lic dust can cause an electrical hazard.
Hold power tool by insulated gripping surfaces,
when performing an operation where the cut-
ting accessory may contact hidden wiring or its
own cord. Cutting accessory contacting a
"live" wire will make exposed metal parts of
the power tool '"live" and shock the opera-
tor.
Before putting into operation, check the mains
connection and the mains plug for damage.
Examples of such materials and therein con-
tained chemicals, where hazardous dusts can
develop when working them, are:
– Asbestos and materials containing asbestos;
– Lead-containing coatings, some wood types
such as beech and oak;
– Minerals and metal;
– Silicate particles from bricks, concrete and
other materials containing stone;
– Solvent from solvent-containing paint/var-
nish;
en
5