Troubleshooting Table; Disposal Of The Old Device - Caso GERMANY FastVac 3000 Manual Del Usaurio

18.2 Troubleshooting table

Fault
Device does not turn on
A complete vacuum is
not being created in the
bag.
The bag is not being
sealed correctly
The bag does not hold
the vacuum after it has
been sealed
The device is switched
off after repeated
vacuuming
► In the event of technical troubles, faulty devices or missing parts,
please contact Customer Service.

19 Disposal of the Old Device

To protect the environment, it's important to dispose of old electronic
devices properly. Do not place your old unit in the non-recyclable waste
under any circumstances.
Please take your old unit to the nearest recycling center for safe
►
disposal.
Until it can be disposed of properly, store your old unit away from
►
children.
caso FastVac 3000
Possible Cause
Defective power cord
The open end of the bag is not
completely inside the vacuum
chamber
The bag is defective
There is residue on the welding
and the seal
The sealing bar is overheating
so that the bag melts
Roll / bag is not positioned
correctly.
The bag is defective
There are leaks along the
welding seam as a result of
creases, crumbs, grease or
liquids.
The device is cooling down, in
order to prevent overheating.
PLEASE NOTE
PLEASE NOTE
To Rectify
Send device to Customer Service
Position the bag correctly
Select another bag
Clean the welding / seals and retry
once they are dry
Open the cover on the unit and let it
cool down for a few minutes. Please
use only specified bags and rolls
Carefully follow all the steps in
Chapter "Vacuum with a bag of the
bag roll".
Select another bag; wrap paper
around any sharp edges within the
bag.
Open the bag again and clean the
upper internal part of the bag.
Remove any foreign matter that
might be on the welding bar before
sealing.
Wait half an hour until the device has
cooled down, you can use it again
50