Installing And Cleaning Cartridge Filter - EWT CS 4 COMFORT Manual Del Usaurio

INSTALLING AND CLEANING
1
6
Installing Cartridge Filter
1. Verify that the power cable is disconnected from the outlet (Fig.1).
2. Remove power head and place in upside down position.
3. Install the cartridge filter over the filter cage with the flat end of the filter towards the vacuum power ead.
Carefully push filter in until it stops against the power head (Fig. 2 & 3).
4. Place filter retainer on top of cartridge filter over the raise lip (Fig.4) and tighten down by turning retainer
clockwise, do not over tighten (Fig. 5). Replace the power head on to the container.
Removing and Cleaning Cartridge Filter
1. Unlock and remove the filter retainer by tuning retainer handle counter clockwise.
2. Carefully hold and pull the cartridge filter up for removal (Fig. 6).
3. Clean the cartridge filter by gently tapping or brushing dirt off. Cleaning should not be done indoors in
living areas. For optimal performance a new filter is recommended.
4. Install cleaned or new filter into place as instructed above in steps 2 and 3 of Installing Cartridge Filter.
5. Wet filters should be removed and allowed to air dry for 24 hours before installing onto the filter cage.
CARTRIDGE FILTER
2
3
42
4 5