Abicor Binzel ABIPLAS WELD 100 POWDER W Instructivo De Servicio página 47

®
ABIPLAS WELD 100/150 POWDER W
12 Disposal
12.1 Materials
12.2 Consumables
12.3 Packaging
When disposing of the system, local regulations, laws, provisions, standards
and guidelines must be observed. Observe the regulations on the disposal of
electronic scrap and dispose of it at your local waste disposal site (e.g.
recycling centre).
To correctly dispose of the product, it must first be disassembled. Please take
note of the following information:
 11 Disassembly on page EN-22
This product is mainly made of metallic materials, which can be melted down
in steel and iron works and are thus almost infinitely recyclable. The plastic
materials used are labelled in preparation for their sorting and separation for
later recycling.
Oil, greases and cleaning agents must not contaminate the ground or enter the
sewage system. These materials must be stored, transported and disposed of in
suitable containers. Please observe the relevant local regulations and disposal
instructions in the safety data sheets specified by the consumables'
manufacturer. Contaminated cleaning tools (brushes, rags, etc.) must also be
disposed of in accordance with the information provided by the consumables'
manufacturer.
ABICOR BINZEL has reduced the transport packaging to the necessary
minimum. The ability to recycle packaging materials is always considered
during their selection.
12 Disposal
EN - 23