Automated Learning Process/Activating Code - Harbor Breeze E-AER52BRZ5LKRCI Manual De Instrucciones

AUTOMATED LEARNING PROCESS/ACTIVATING CODE

CAUTION: The remote control transmitter (G) can
be programmed to multiple receivers or fans. If this is
not desired, turn wall switch off to any other
programmable receiver or fan.
Remove battery cover from back of remote control
1.
transmitter (G).
Locate battery (Q) in hardware pack, then remove
plastic wrap from battery (Q). Install battery (Q) but
leave battery (Q) outside of battery compartment
until learning process is complete.
2. Locate dimmer switch on left-hand side at top of
battery compartment. Dimmer switch has been
pre-set to the "ON" position (DIM). [Note: If you
prefer not to have dimming capability, set the
dimmer switch to the "OFF" position (ON/OFF)].
Place battery (Q) in battery compartment and then
replace battery cover on back of remote control
transmitter (G).
3. Restore electrical power. Within 30 seconds of
restoring electrical power, press the "LEARN"
button, located on right-hand side at top of battery
compartment, for 3 seconds or until fan switches to
MEDIUM speed. Use the remote control transmitter
(G) to test the light and fan functions (see Operating
Instructions for Remote Control and Fan on page
15) to confirm the learning process is complete.
IMPORTANT: To prevent damage to remote control
transmitter (G), remove the battery (Q) if not used
for long periods. Store the remote control transmitter
(G) away from excess heat.
1
(back)
2
ON/OFF
DIMMER
SWITCH
3
G
Lowes.com/harborbreeze
14
G
9V
Q
Battery
Cover
G
ON/OFF
9V
(back)
Battery Cover
ON/OFF
LEARN
BUTTON
ON/OFF
9V
Q
R