FAN MOUNTING
1.
Lift the preassembled yoke plate and the top of
motor housing (D) from motor and set aside.
2.
Insert the blade (F) through the slot on the band on the
motor housing (D). Align holes in blade (F) with holes
inside motor. Partially insert three blade screws (AA),
along with three fiber blade washers (BB), to attach
blade (F) to motor. Then tighten each blade screw (AA),
starting with the one in the middle. Repeat procedure
for remaining blades (F).
Time Saver: Fiber blade washers (BB) can be set on
each blade screw (AA) prior to installing blades (F).
Hardware Used
AA
Blade Screw
BB
Fiber Blade Washer
3.
Replace top of motor housing (D) and yoke plate
and secure with motor screws (I) and lock washers
(K) previously removed (Step 5, page 7).
IMPORTANT: Circular cutout on motor housing
(D) and yoke plate should line up over electrical
wiring and the opening for the reverse switch
should line up with the reverse switch.
1
2
D
Center
Band
x 15
x 15
3
Circular
Cutout
D
8
Yoke Plate
E
I
K
Yoke Plate
Lowes.com/harborbreeze
D
AA
BB
F
Slot
Reverse
Switch