JENN-AIR 720-0727 Instrucciones De Instalación Y Manual De Uso Y Cuidado página 22

3. Light grill using information in the "Outdoor Grill Use" section.
4. Turn burner to its lowest setting.
5. Remove each control knob for the main burners and side
burner by loosening the setscrew with the Hex key.
6. Hold valve stem with pliers and insert a small flat-blade
screwdriver into the shaft.
7. Watch the flame and slowly turn the screwdriver
counterclockwise.
8. Adjust flame to minimum stable flame.
A
A. Valve stem
B. Small flat-blade scr ewdriver
C. Pliers
9. Replace the control knob and turn off the burner.
10. Repeat steps 3 through 9 for each burner if needed.
11. Replace the flame tamers and grates after the burners
have cooled.
Check Operation of Oven Burner
1. Open oven door .
2. Press in and turn the oven control knob to 350°F
The oven burner should light in 20-40 seconds; this delay
is normal. The oven valve requires a certain time before
it will open and allow gas to flow.
To avoid damaging the hot surface igniter, do not insert any
object into the openings of the shield that surrounds the igniter.
Do not clean that area.
3. Check the oven burner for proper flame. The flame should be
½"(0.13 cm) long, with inner cone of bluish-green. The outer
mantle should be dark blue and should be clean and soft in
character. No yellow tips (not enough air), blowing or lifting
(too much air) of flame should occur.
22
B
C
.
If the flame needs adjusting:
1. Turn the oven off. Wait for the oven burner to cool down.
2. Open oven door and remove oven racks. Remove oven bottom
cover by lifting up and out. Set oven racks and oven bottom
cover aside.
1
A. Oven bottom cover
3. Remove flame spreader and set aside.
A
B
4. Locate the air shutter near the rear wall of oven and loosen the
shutter screw.
A. Shutter screw
B. Air shutter
5. Adjust the air shutter.
6. Turn the oven back on and check for proper flame. If the flame is
still not properly adjusted, turn the oven off, wait for the oven
burner to cool down and repeat Step 4 until flame is properly
adjusted.
7. When the flame has been properly adjusted, turn the oven off,
wait for the burner to cool down.
8. Tighten the shutter screw.
9. Reinstall flame spreader and oven bottom cover. Reinstall the
oven racks.
10. Close the oven door.
A
A. Screws
B. Flame spreader
A
B