Machine Setup - Tornado MINI-MARATHON 425 Manual Del Usario

MACHINE SETUP

1. Carefully check carton for signs of
damage. Report damage at once to
carrier. The machine is shipped fully
assembled and is ready for use.
2. Adjust handle from transport position.
To adjust, loosen handle knobs, lift
handle to desired operating height,
tighten handle knobs to lock handle
(figure 4).
3. Lift recovery tank cover and remove
recovery tank. Make sure the float shut-
off screen and solution tank strainer are in
place before use (figure 5).
4. Using a clean bucket or hose, fill solution
tank with 4 gallons (15 L) of hot water, 140°F
(60°C) maximum. Observe solution tank hose at
rear of machine when filling (figure 6). The hose
indicates the amount of water in solution tank. Do
not use recovery tank to fill machine. Use a clean
bucket. (Figure 7).
Figure 4
Figure 5
cover after filling.
wall outlet. (Figure 8).
8
ATTENTION: Do not use recovery
tank to fill solution tank. Residual dirt
or debris could cause damage to the
solution pump.
WARNING: Flammable materials
can cause an explosion or fire. Do not
use flammable materials in tank(s). Add
a recommended cleaning fluid.
5. Replace recovery tank and close
6. Plug power cord in a grounded
Figure 6
Figure 7