Installing Color Filters; Connecting The Power Supply - Optika Italy IM-3 Serie Manual De Instrucciones

4. Push the LED housing gently into the holes of the
illumination unit. (Fig. 9)
7.4.6 Installing color filters
• Remove the filter holder, then install the color
filter you need. (Fig. 10 - 11)
Mount the color filter flat as shown in ①, verifying that
they are not tilted.
• If the color filter is tilted or otherwise out of
place ②, it may fall.
②
The color filters can be stacked in the holder. This al-
lows to install as many filters as needed, as long as
the whole thickness is less than 11 mm.

7.4.7 Connecting the power supply

1. Turn the main switch to "O" (OFF) before con-
necting the power supply.
2. Insert the jack of the power supply into the power
socket of the microscope. (Fig.12)
3. Plug the power supply into the mains socket.
Check for a safe connection.
• Please use the provided power supply. If lost
or damaged, please refer to qualified service.
• Connect the power supply to a grounded
(earthed) wall outlet only.
①
Page 12
Fig. 9
Fig. 10
Fig. 11
Fig. 12