SRAM Rock Shox PIKE Manual De Instrucciones página 11

SRAM C
• 32
ORPORATION MM
In the 'Lock' position, the Motion Control system allows for a small amount of
controlled fork movement. This movement enables the front tire to track the terrain
without deflecting off o b s tacles, allowing for better traction and steering control when
compared to a complete lockout system. To activate the 'Lock', turn the crown-
mounted blue compression adjuster full clockwise or press forward on the PopLoc
Remote lever located on the handlebar.
F A
L O O D G AT E D J U S T M E N T
All forks with Motion Control Damping allow for fine-tuning of the 'Lock' s e t t i n g . The
rider can choose the point at which the 'Lock' setting can 'blow-off' and become active
to force inputs such as bumps or rocks. This adjustment is made using the Floodgate.
Depending upon fork model, the Floodgate is adjusted either internally (requires a
2.5mm hex wrench) or externally with the gold 'Gate' adjuster.
For crown mounted adjusters, hold the adjuster in the 'Lock' position while adjusting
the internal Floodgate.
N : T F
OTE HE LOODGATE IS INTENDED TO ADJUST THRESHOLD OF
W F
HEN PERFORMING LOODGATE ADJUSTMENTS
'L .'
TO OCK
Under 'Lock', the maximum Floodgate setting results in a fork with minimal movement
while the minimum Floodgate setting results in increased fork movement.
N : F
OTE OR MAXIMUM FORK SENSITIVITY AND MOVEMENT
Floodgate settings should be used to adjust suspension compliance to medium sized
bumps and resistance to rider induced suspension movement (referred to as "bob") in
the 'Lock' mode. When properly tuned, the Motion Control System will resist "bob," but
SRAM C • J
ORPORATION ANUARY
XC A M F
AND LL OUNTAIN ORKS
Fig. 2
( F . 3) (P , R
IG IKE
O N LY)
'L
OCK
,
ENSURE THAT THE
,
RETURN THE FORK TO THE
2005
E
U M
SER ANUAL
R
E V E L ATION A N D E B A
' - 'L '
BLOW OFF IN THE OCK MODE ONLY
M C
OTION ONTROL SYSTEM IS ADJUSTED
'O '
PEN POSITION
NGLISH
.
.
11