Panel Mounting; Connections - Crison MultiMeter 44 Manual Del Usuario

3.3

Panel mounting

Figure 5 Panel mounting
1
R5 mm
206 mm
[8.11 in]
Measurements to punch the panel where the instrument
1
will be installed
Adapters for panel mounting
2
3.4

Connections

3.4.1 Safety information
The voltage across accessible parts of the instrument may be dangerous to life.
The IP 65 protection only applies to the front part of the instrument (with door closed and MP-5
connector covered). In panel mounting installation the overall IP protection of the instrument will
depend on the panel and instrument installation.
Four adaptors for panel mounting are supplied with the instrument
instruments are installed without the rear cover.
1. Completely open the transparent door and pull to remove it, see
Note: Make sure that you do not misplace the black hinges of the transparent door.
2. Unscrew the four screws for the extraction of the frontal part of the instrument, see
Figure 4.
3. A hole as indicated in figure 10 is required in the panel.
4. Use the four adaptors to screw the instrument in the panel.
5. Mount the transparent door.
2
202 mm
[7.95 in]
When making any wiring connections to the instrument, any warnings and notes found
throughout the manual must be adhered to. For more safety information refer to
section 2.1, page 7.
D A N G E R
4 screws of the frontal cover, see
3
Instrument mounted
4
Installation
. Panel
MULTIMETER 44
Figure 4.
4
3
Figure 4
15