Factory Programming; Profibus Programming - Crison MultiMeter 44 Manual Del Usuario

Figure 32 PROFIBUS channel
220
5.3.2 Sent data
5.3.3

Factory programming

5.3.4

PROFIBUS programming

RS 232
1 2
390
390
MultiMeter 44 does not have internal terminator resistors. For this reason, resistors should
be installed on the communication cable of the last instrument, as indicated in
Every channel sends the following information:
Channel status (1 byte) Information about the status of relays, alarm, etc.
•
Units (1 byte).
•
Measured value (4 bytes).
•
Temperature, ºC (4 bytes).
•
The size of the sent data block is 30 bytes.
MultiMeter 44 sends the data in the following order:
Address byte Data
0 Channel 1 status
1 Measuring units in Channel 1
2 Measured value with Channel 1
6 Temperature Channel 1
10 Channel 2 status
11 Measuring units in Channel 2
12 Measured value with Channel 2
16 Temperature Channel 2
20 Channel 3 status
21 Measuring units in Channel 3
22 Measured value with Channel 3
26 Temperature Canal 3
1. From the main menu select
2. Select
CONFIGURE PROFIBUS
3. The user has the following possibilities:
Relays
Alarm Cleaning
3 4 5 6 7
Table 5-1Memory Map
SYSTEM > CONFIGURE INSTRUMENT
and confirm.
Advanced operations
Mains Fuse
110/230V: T100L 250V
N L
24V: T500L 250V
8 9 10
Figure
. Confirm.
32.
67