Crison MultiMeter 44 Manual Del Usuario página 61

k. Control characters <LF> <CR> <ETX>
Table 5 Example of data sending "Send data to PC", data format 1 Channel for
1 ; C ; 60801 ; XXXXXXXX ; 07-01-2007 ; 12:40 ; C1 ; pH ; Pot asym: 3 mV ; Slope: 57.15 ;
Temp: 25 ºC;
2 ; M ; 60801 ; XXXXXXXX ; 07-01-2007 ; 13:00 ; 0 ; 0 ; 0 ; 0 ; C1 ; pH ; 4.10 ; ; 25 ; ºC;
3 ; M ; 60801 ; XXXXXXXX ; 07-01-2007 ; 13:00 ; 0 ; 0 ; 0 ; L2 ; C2 ; mV ; 715 ; ; 25 ; ºC;
2. Sending data to PC2: Data Format all channels
a. Control character <STX>
b. Index.
c. Indicator of measurement data, XM.
d. Serial number of the instrument and instrument name.
e. Date and hour.
For each channel:
f.
Channel number: C1, C2 or C3.
•
Type of measurement: pH, EC, DO, etc.
•
Measured value and units.
•
Temperature value and units.
•
g. Situation of relays:
Cleaning relay
Channel Alarm
Sensor Alarm
Limit 1
Limit 2
Note: If the relay is disconnected, space in blank is sent.
h. Control characters <LF> <CR> <ETX>
Table 6 Example of data sending "Send data to PC 2", data format all Channels for
708 ;XM; 60801; NOM EQ.;19-03-09;14:42:35; C1; pH;10.85; ;20.5; ºC; 0; 0; 0; 0; 0; C2; OD;
0.00; ppm; 25; ºC; 0; 0; 0; 0; 0; C3; CE; 2.76; mS; @25ºC; 0; 0; 0; 0; 0;
Calibration data
After calibration of any of the sensors, the instrument will send the following data:
a. Control character <STX>
b. Index.
c. Indicator of calibration data, C.
d. Serial number of the instrument.
e. Date and hour.
Channel number sending the calibration data.
f.
g. Type of measurement, pH, EC, DO, etc.
each line <message>:
Connected
L
A
AS
L1
L2
each line <message>:
Advanced operations
59