Data Request From Pc - Crison MultiMeter 44 Manual Del Usuario

Advanced operations
5.1.2.2 Data sending from Data Logger
5.1.3

Data request from PC

5.1.4 Data sending through GSM "SMS"
60
h. Calibration data.
Control characters <LF> <CR> <ETX>
i.
The stored data, measurements and calibrations, in the Data Logger of MultiMeter 44 can
be sent at any moment. The data from the Data Logger are identified with DL, it means:
DLM, measurements data coming from the Data Logger.
•
XDLM, format as "All Channels"
•
DLC, calibration data coming from the Data Logger.
•
The rest of fields are identical to the on-line sending.
•
1. From the main menu select
2. Select
SEND DATA RS 232
The request for data from the PC can be carried out from the standard application
Hyperterminal of Windows. The process is the following:
1. From the main menu select
2. Select
RS 232 COMUNICATION
3. Select
SEND DATA TO PC
4. Select
DATA REQUEST
5. From the computer, send the character "$" (24 hexadecimal) followed by carriage
return (CR, Od hexadecimal).
6. The instrument will sent a message with the data in "Data Format All Channels" (see
Measuring data, page
Note: If one of the channels does not exist, the instrument sends "?" as a type of measurement and
the rest of data in blank.
Select this option when GSM module with operative SIM card is connected to the
instrument, see accessories for MultiMeter 44 at
accessories, page 75.
Code 44 96: GSM module for messages sending to mobile phone. It includes union cable
to MultiMeter 44, antenna and power supply.
1. Connect the GSM module to the RS232 connection of the rear panel, see
1. From the main menu select
2. Select
RS 232 COMUNICATION
3. Select . Once SMS is selected, the option SMS will appear at the System menu.
SMS
4. Select
SYSTEM > SMS > PROGRAM MODEM
5. Introduce the following data using the keypad:
No. Tel: The phone number to which the messages will be sent.
•
Pin: PIN number of the card installed in the GSM module.
•
6. Press to accept the data.
CONTINUE
7. Select
START MODEM
CONSULT DATA LOGGER
and confirm.
SYSTEM > CONFIGURE INSTRUMENT
and confirm.
or
SEND DATA TO PC 2
and confirm.
58).
Section 8 Replacement parts and
SYSTEM > CONFIGURE INSTRUMENT
and confirm
and confirm.
to Initialize the modem.
. Confirm.
. Confirm.
and confirm.
. Confirm.
Figure 30.