Preparing The Sprayed Medium; Preparing The Surface To Be Sprayed; Q Preparing The Surface To Be Sprayed; Bringing Into Use - Parkside PFS 100 B2 Instrucciones De Utilización Y De Seguridad

Advice on use / Bringing into use
5. Remeasure the DIN-seconds value.
Repeat this procedure until a value is obtained
that complies with the values in the table.

Preparing the sprayed medium

Q
NoTE: Most paints, varnishes etc. in the shops
are intended to be applied by brush not spray. To
achieve the best spraying result, you should prepare
your paint or varnish etc. in accordance with DIN
guidelines to achieve a suitable viscosity (see table).
Use a suitable thinner to achieve the required
thinning of the medium.
N ever exceed the maximum viscosity for the
device. The sprayed medium must not be too
thick for the spraying process, otherwise it
could clog up the device.
E nsure that the sprayed medium and the thinner
are compatible with one another. If the wrong
thinner is used, it can lead to lumps forming
which may clog up the device. Never mix nitro-
thinners with synthetic resin paint.
C onsult the sprayed medium manufacturer's
documentation for information about suitable
thinners (water, solvents).
1. Thoroughly mix the unthinned sprayed medium
and bring it to average room temperature
(20 - 22 °C).
Do not increase the temperature to change the
viscosity.
2. Add a suitable thinner.
3. Test the viscosity as described above (see Fig. C).
NoTE: Never use nitro-thinners to thin synthetic
resin paint!
Example of
material
Car body paint
Acrylic paint
Synthetic resin paint
Primer
Wood impregnation
glaze
40 gB/MT
DIN guidance
value
16-20 DIN-sec
25-30 DIN-sec
25-30 DIN-sec
25-30 DIN-sec
25-30 DIN-sec
25-30 DIN-sec
Example of
material
Hammer finish paint
Emulsion paint
* This device cannot be used to spray media contain-
ing discrete particles / solids. The abrasive effect
of these media shortens pump and valve life.
Preparing the surface
Q
to be sprayed
The surface to be sprayed must be clean, dry and
free of grease.
R oughen smooth surfaces and remove any
abraded dust.
A lways cover the surrounding area around the
surface to be sprayed. The spray cloud may
contaminate the surrounding area.

Bringing into use

Q

Selecting the nozzle

Q
Nozzle
Nozzle, 0.6 mm
Nozzle, 0.8 mm
Cleaning nozzle
Nozzle extension

Switching oN / oFF

Q
Switching on:
T o start the electrical power tool, press the
oN / oFF switch
3
DIN guidance
value
30-35 DIN-sec*
40-80 DIN-sec
Use
all paints, varnishes
thick-flowing sprayed
media
a thinner, harder spray
for spot-cleaning of sur-
faces
for spraying in high or
low, more difficult to
reach corners
and keep it pressed.