Preparing The Spray Surface; Before Use; Charge Battery Pack (See Fig. B); Attaching/Disconnecting The Battery Pack To/From The Appliance - Parkside PFSA 20-Li A1 Traducción Del Manual De Instrucciones Origina

Ocultar thumbs Ver también para PFSA 20-Li A1:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 106

Preparing the spray surface

Cover the area around the spray area thoroughly
and over a wide area. Any surface that is not
masked could become contaminated.
Make sure that the spray surface is clean, dry
and free of grease.
Polished surfaces should be lightly sanded and
the sanding dust removed.

Before use

Charge battery pack (see fig. B)
CAUTION!
Always unplug the appliance before you
remove the battery pack
to the charger.
NOTE
Never charge the battery pack at an ambient
temperature of below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level must be
checked regularly. The optimum charge level
is between 50% and 80%. The storage
climate should be cool and dry and the
ambient temperature should be between 0°C
and 50°C.
Insert the battery pack
charger
.
Insert the power plug into the socket. The red
control LED
lights up to indicate that the
appliance is charging.
The green LED
indicates that the charging
process is complete and the battery pack
is ready.
Push the battery pack
GB │ IE
8 
from or connect it
into the high-speed
into the appliance.
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack
Push the battery pack
it clicks into place.
Removing the battery pack
Press the release button
battery pack
.

Checking the battery charge level

Press the battery charge level button
check the charge level of the battery. The status
is indicated in the adjacent battery display LED
as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Setting up

Assembly/disassembly

Move the ▸ mark on the spray unit
mark on the motor unit  . Now, turn the spray
unit
until the ▸ mark on the spray unit
locks into the
mark on the motor unit
Release the catch
5a
the spray unit
to the
unit
to separate the two units.

Selecting/changing the nozzle

Nozzle
Use
all types of paints and
1.8 mm nozzle
lacquers
viscous spray material
2.6 mm nozzle
Undo the union nut
it from the spray unit
Fit the desired nozzle
head
.
Screw the union nut
unit
.
into the handle until
and remove the
to
to the
.
. Turn the ▸ mark on
mark on the motor
completely and remove
.
onto the nozzle
back onto the spray
PFSA 20-Li A1

Publicidad

Tabla de contenido
loading

Tabla de contenido