entrematic Ditec Sector Manual De Instalación, Manutención, Uso página 32

SIGNALS ANd SETTING
49E
Trimmer
TC
0 s 30 s
RP
0 s 30 s
ditec Sector
dip-switches
setting
ON
1 2 3 4 5 6
jumpers
Reversal safety switch
SO
function.
EO Electric brake.
LEd
POWER 24 V= power supply.
Indicates that at least one of the safety
SA
contacts is open. ( 6 - 8 - 9 )
Activated at every command and
IN
adjustment to the dip-switch and jumper.
Indicates that the 0-11 limit switch
11
contact is open.
Indicates that the 0-12 limit switch
12
contact is open.
Indicates that the 0-17 limit switch
17
contact is open. (not used)
Button
ON
Starts the opening operation.
Starts the partial opening operation.
Starts and stops the STOP operation.
Starts the closing operation.
0DT827 2014-06-13
Setting automatic closing time. From 0 to 30 s.
Note: after the activation of the stop command, once contact 1-9 has closed again, the
automatic closing is only activated after a total, partial or step-by-step opening command.
Motor partial opening adjustment. From 0 to 30 s.
dip - switch
dIP 1 Control 1-3 function.
Restore automatic closing
dIP 2
time.
dIP 3 Preflashing set at 3 s.
dIP 4 Application type.
dIP 5 dynamic brake.
dIP 6 double speed
description
With the automation blocked, if the
contacts 1-8 or 41-8 are open, it is possible
to activate the opening operation.
Do not use
On
The green LED on indicates the presence of the 24 V=power supply.
the red LED on indicates that the STOP has been activated.
the flashing red LED indicates that the safety devices have been activated.
description
description
OFF
- Indicates the STOP operation activated by pushbutton panel
PT4 (if present).
- If the AUTOTEST device is installed, this indicates a safety
test failure (terminal 41).
- On power on, the LED flashes to indicate the number of
operations performed:
each rapid flash = 10000 operations
each slow flash = 100000 operations
- 32 -
OFF
Step-by-Step Opening
Do not use 100 %
Disabled during Enabled for both
opening opening and closing
Do not use Rapid door
Disabled Do not use
Disabled Do not use
With the automation blocked, if
the contacts 1-8 or 41-8 are open,
any operation is impossible.
Normal.
Flashing
/
/
/
/
/
LEd
ON
ON