Electric Connections; Control Panel; Connecting The Control Panel / Automation; Safety Photocells - entrematic Ditec Sector Manual De Instalación, Manutención, Uso

4. ELECTRIC CONNECTIONS

4.1 Control panel

• Insert the cables with pre-wired terminal boards in the housing, and connect them to the cards (fig.13). Fit the cables in
the conduit and connect the connectors on the motor (fig.14).
4.2 Connecting the control panel / motor / security
• Figure 15 shows the layout of the cables supplied, and their position in the door; each cable is identified by a special code
on an adhesive label.

4.3 Safety photocells

• Wire the device as per the diagram (fig.15).
• Make the connections in the control panel, as shown in the diagrams
Correctly size the line conductor cross-section by referring to the indicated absorption and taking the length and
installation of the cables into account.
13
0 1
Rx2
C T
0 1
Tx1
- 29 -
A935G/E
0 1
Tx2
0 1
Rx1
0DT827 2014-06-13
EN
14
15