Electrical Safety - Jacuzzi Profile Performance Ficha Técnica De Preinstalación

trical mains easier, the electrical box is equipped with a cable
clamp M32 x 1.5mm.
I
The installer must comply with the above regulations, and al-
so use watertight connectors at connection points. He
must also guarantee compliance with the specific current
standards for systems in the country in which the spa is
installed.
It is mandatory to comply with this instruction. Any oth-
er procedure is prohibited.

Electrical safety

Profile is a safe appliance, manufactured according to EN
60335.2.60, EN 61000, EN 55014 regulations and tested dur-
ing production to guarantee user safety.
I
Installation must be carried out by qualified and authorized per-
sonnel, in compliance with current national provisions.
It is the responsibility of the installer to select ma-
terials based on their intended use, to carry out
work properly, to check the condition of the system
that the unit will be connected to and that it en-
sures safety of use, also concerning maintenance
work and the possibility to examine the system.
I
The Jacuzzi ® spas are class "I" appliances and therefore they
must be permanently connected, without any intermediate
connections, to the electrical system and to the protection sys-
tem (earth system).
The electrical system of the building must be pro-
vided with a 0.03A differential switch and with an ef-
ficient protection (earth) circuit.
Check for proper operation of the differential switch
by pressing the TEST button, which should trip.
Parts incorporating electrical components, except
remote control devices, must be located or fixed so
that they cannot fall into the spa.
Live components and equipment must be out of
reach of individuals in the spa.
I
For electrical connections, the installation of a multiple-pole
section switch is compulsory (
place that complies with safety regulations and, in any case,
which cannot be reached by those using the spa.
It is mandatory to comply with this instruction. Any oth-
er procedure is prohibited.
I The disconnection devices must be installed in the power supply net-
work according to the installation instructions.
I
The installation of electrical devices and equipment (sockets,
switches, etc.) near the spa must be in compliance with legal s-
tandards and regulations in the country where the spa is in-
stalled.
i
4). It must be positioned in a
I
For the equipotential connection as required by specific na-
tional standards, the installer must use the terminal provided (s-
tandard EN 60335.2.60) under the electrical box (
marked with the symbol
dition must be established for all metallic masses surrounding the
spa, for example water and gas pipes, metallic platforms, and so
on.
I
The appliance comes equipped with an LED lighting system, in com-
pliance with Regulation EN 62471:2009.
CAUTION! Before carrying out any maintenance opera-
tion, disconnect the appliance from the power supply line.
15
i
.
In particular, an equipotential con-
4), and