GYS PEARL 150-2 Manual De Instrucciones página 9

SETTINGS PANEL (FIG V)
1
2
3
4
5
Advices
The wire speed adjustment is often determined « by the noise »: the arc must be stable
and have a low crackling.
If the speed is too low, the arc is not continuous.
If the speed is too high, the arc crackles and the wire pushes back the torch.
PROCESS OF REELS AND TORCHES ASSEMBLY (FIG IV):
• Remove the contact tube and its support (fig D), and the nozzle (fig E) from the torch.
Fig A : • Position the wire reel on the reel support :
- The adapter (1) is to be used only for 200mm wire reel assembly
• Adjust the reel brake (2) to avoid reel movement tangling the wire when welding stops. Be careful not to tighten
too much.
Fig B : • The drive rollers included have 2 grooves (0,6 and 0,8). The visible diameter indicated on the roller when
fitted in place is the diameter currently in use (ie. 0.8mm is visible for use with 0.8mm wire). To weld aluminium or
gasless wire, use the appropriate drive rollers.
Fig C : To select the adjustment of the drive rollers
• Loosen the drive roller knob (4) as far as possible and insert the wire, tighten the knob again slightly
• Start the motor by pressing the trigger of the torch
• Tighten the knob whilst pressing the trigger until the wire starts to move.
Nb : When welding with Aluminium, use the minimum possible pressure to avoid crushing the wire
• Leave about 5cm of wire out of the torch, then put the contact tube (fig. D), and the nozzle (fig. E) adapted to the
wire to be used at the extremity.
GAS COUPLING
The PEARL is equipped with a "screwed" connection. Use the adapter supplied with your machine.
DUTY CYCLE & WELDING ENVIRONMENT IN USE
• The welding unit describes a flat output characteristic (constant voltage). The duty cycles following the standard
EN60974-1 (at 40°C on a 10mn cycle) are indicated in the table here below:
X / 60974-1 @ 40°C (T cycle = 10 min)
PEARL 150.2
Note : The machine's duty cycle has been tested at room temperature (40°C) and has been determined by simulation.
PEARL 150-2
• Green light «ON»: when the machine is switched
on the light turns on.
• In case of power failure (red light) the green light
goes off but the device is turned on.
• Orange light: in case of excessive temperature
the light switches on when the device is on thermal
protection mode for cooling it.
• Red light: In case of power failure, the light turns
on and the machine goes into safe mode.
• Left button: to adjust the wire speed up to 12m/
min.
• Right button: to adjust the welding voltage up to
21.5V
I max
26% @ 150 A
60% (T cycle = 10 min)
90 A
EN
100% (T cycle = 10 min)
80 A
9